What "drain tile" means
The name comes from the clay tile sections that were laid around footings decades ago. Today it almost always means perforated plastic pipe set in gravel. It sits at or near the level of the footing, collects water before it builds up pressure, and carries it to a sump pit where a pump sends it outside.
There are two main kinds.
Interior drain tile
The contractor cuts out a strip of the basement floor along the walls, digs a trench beside the footing, lays pipe in clean gravel, and pours new concrete over it. Water that would have seeped through the floor joint drops into the pipe instead. Block walls are often drilled at the bottom course so water trapped in the hollow cores can drain into the system. A plastic dimple membrane is often added along the wall so seepage runs down behind it into the trench.
Interior systems are the most common choice for existing homes. They can be done in any season, they don't disturb landscaping, driveways or decks, and they deal directly with water coming up from below.
Exterior drain tile
The contractor digs down the outside of the foundation to the footing, lays pipe beside it, applies a waterproofing membrane to the outside of the wall, and backfills with gravel and soil. This stops water before it reaches the wall at all.
It's more disruptive and usually more expensive, but it makes sense when a wall needs exterior repair anyway, when the basement is finished and you don't want to tear it up, or for new construction.
Why drain tile matters so much in Kalamazoo
The local problem is groundwater. Officials have tied recent rounds of basement flooding in Kalamazoo and Portage to unusually high groundwater: in 2018, after record rainfall, and again in spring 2026, when the City of Kalamazoo declared a flooding emergency. When the water table rises over your basement floor, the water comes up, not in. A drain tile system with a working sump is the standard way to relieve that pressure.
Some older homes around Kalamazoo do have original clay tile around the footings. After many decades, it's often clogged with silt, crushed or disconnected, and in some houses it was never tied to a sump at all. A camera inspection or a test hole can show what's down there.
Questions to ask the contractor
- Will the pipe sit beside the footing or on top of it?
- What size gravel and pipe will you use, and is the pipe wrapped in filter fabric?
- Will you drill the block cores?
- Where does the water go, and does the discharge line carry it far enough from the house?
- How many sump pits does the basement need, and is a battery backup included?
- What happens around the furnace, water heater and stairs?
- Is there access for cleanouts if the system ever needs to be flushed?
- What written warranty do you offer? Warranty terms come from the contractor, so get them in writing.
What does drain tile cost in Kalamazoo County?
National cost guides commonly put interior drain tile at about $40 to $100 per linear foot. For a whole basement perimeter with a sump pit and pump, totals often land somewhere around $4,000 to $12,000. Larger basements, finished walls that have to come down, multiple pits or difficult access can push it higher. Exterior systems usually cost more because of the digging. The contractor we connect you with will give you a quote after measuring and inspecting.
Drain tile and radon
Kalamazoo County is an EPA Zone 1 county for radon. An interior drain tile system and a sealed sump lid can sometimes be set up to work with a radon mitigation system, since both pull from beneath the slab. If you haven't tested for radon, it's worth doing before the floor is opened. Ask the contractor whether they can plan for that.
Related services
Drain tile almost always goes with a sump pump. If walls are cracked or bowing, see foundation and wall repair as well. For a home with a crawl space instead of a full basement, see crawl spaces. We help homeowners in Portage, Parchment and the rest of the county. Call (269) 348-0880.